![]() ![]() The ones I have seen are 2 x 1 inch rectangular tubing with an 1/8 inch wall thickness. Hypothetical question: Say your AWD car is on 4 jack stands with all the wheels off of the ground. You can just use 1 inch square tubing for the base but will need something stiffer for the long cross bar so it doesn't bend over time. Home > Floor Jacks > 12 Late Model/ Stock or Modifieds Race Car Roll Around Jacks. (1) Estimated to ship direct from manufacturer on 04/18/23, pending manufacturer availability. The width between the cars main frame rails is 31 inches so you should make them at least 32 inches wide or make two shorter ones to use on either side. JOES Racing Products Stock Car Jack Stands 14' Height. The quick jacks typically raise the car about 7 inches off the ground so you want to make you jack stands between 6-6.5 inches tall. The BP-10 2-post lift, floor base-plate, 10,000lbs lifting capacity, Super-symmetric arms, direct chain-drive, with three-stage front arms and two-stage rear arms, 1.5', 2. Low jack stands can be easily fabricated by welding some square tubing. When lowering the car use the low jack stands to rest the car on when removing the floor jack then use the quick jack to remove the low jack stands. Good places are in the corners where the side boxes meet the main frame, like in the front near the steering box.Īlways be extremely careful before getting under the car to work. Make sure the jack and jack stands are secure, the jack stands can easily slip on the aluminum sheet underbody. When the car is higher in the air you can place standard jack stands.Īlways place jacks and jack stands under the large frame rails. ![]() To get the car higher up in the air use the quick jack to get it up so that you can then get a floor jack under the frame rails. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |